ROHM BM2P016 | Demoboard BM2P016-EVK-002

Beschreibung

The BM2P016-EVK-002 evaluation board outputs a 12 V voltage from an input of 90 Vac to 264 Vac. The output current provides up to 1.0 A. The BM2P016 PWM type DC / DC converter IC with 650 V MOSFET is used. The BM2P016 contributes to low power consumption by incorporating a 650 V withstand voltage startup circuit. Using current mode control, cycle-by-cycle current limiting provides excellent performance in bandwidth and transient response. The switching frequency is fixed at 65 kHz. At light loads, frequency reduction achieves high efficiency. Built-in frequency hopping function contributes to low EMI. The low on-resistance 1.4 Ohm 650 V withstand voltage MOSFET is built in, contributing to low power consumption and easy design. The optimized EMI design complies with CISPR 22 Class B for noise terminal voltage / radiation.

Eigenschaften

• PWM frequency: 65 kHz
• PWM current mode method
• Frequency hopping function
• Burst operation at light load
• Frequency reduction function
• Built-in 650V start circuit
• Built-in 650V switching MOSFET
• VCC pin under voltage protection
• VCC pin over voltage protection
• SOURCE pin Open protection
• SOURCE pin Short protection
• SOURCE pin Leading-Edge-Blanking function
• Per-cycle over current protection circuit
• AC Correction function of over current limiter
• Soft Start Function
• Secondary over current protection circuit

Weiterführende Informationen

• Datenblatt
• Produktseite des IC-Herstellers